Presets
Playback
Configuration, gears and load
Camera
Layers
Quality
Model check
The science
What you are looking at
A planetary (epicyclic) gearset in brass: a sun gear on the front shaft, N planet gears on a carrier, and an internal ring gear. The three members are coaxial. Choose which one is the input, which one is held by the brake clamp, and which one is the output; the three gauges show the speed of the sun, carrier and ring. All teeth are generated as true involute profiles (20° pressure angle, module 2 mm) from your tooth counts, and each planet is phased to mesh with both sun and ring. The start-up is replayed from rest; the rotation is drawn at a fraction of the real angle (last slider) so you can follow the teeth, while the readouts show true values.
Kinematics
The three members are linked by the Willis relation ωs Zs + ωr Zr = ωc (Zs + Zr) with Zr = Zs + 2Zp. Hold the ring and drive the sun: the carrier turns at Zs/(Zs+Zr) of the sun speed (reduction 1 + Zr/Zs). Hold the carrier: the ring turns backwards at −Zs/Zr. Drive the carrier with the ring held and the sun is spun up by (Zs+Zr)/Zs. A planet spins at ωp = ωc − (ωs − ωc) Zs/Zp. For all N planets to mesh with equally spaced centres, (Zs+Zr)/N must be an integer; the page warns when it is not.
Torque and efficiency
Each planet sees equal tangential forces from sun and ring, so the shaft torques are in the ratio Ts : Tr : Tc = Zs : Zr : −(Zs+Zr). The load is shared by N planets. In the carrier frame only the mesh power P = Ts(ωs − ωc) is lost to friction at each of the two meshes, so η ≈ 1/(1 + 2(1−ηmesh) P/Pout); the last graph compares this with a two-mesh compound train, ηmesh².
Dynamics
With every speed a fixed multiple of the input speed, the reflected inertia is the energy sum Jeq = Σ Jiai² + N(Jpap² + mprc²ac²). The motor, T = Ts(1 − ω/ωnl), accelerates this inertia against the viscous load reflected through the ratio, integrated with RK4.
Honest simplifications
Rigid gears, no backlash, constant mesh efficiency, equal load sharing, no bearing, churning or centrifugal effects. The brass finish, hand wheels and gauges are decoration. The gauge needles show the true rpm of each member. No undercut or profile shift is modelled: for very low tooth counts a real 20° gear would be undercut. With a non-integer assembly condition the planets are drawn at equal spacing anyway and some teeth overlap; real gearboxes use special tooth phasing then.
Checks run in the page
- The four closed-form checks of the 2D page (no-slip contact velocities vs Willis, torque split, steady speed, energy ledger).
- The posed scene nodes are rotated by a small angle and the angular speeds are read back: the Willis residual and the planet-spin law must vanish.
- The rendered tooth profiles of planet 1 are tested for overlap with the sun and with the ring at 12 poses, plus a control with the planet turned half a pitch that must clash.
Credits
Blender 5.2 hand wheels, bearing pillars, brake clamp, rollers and gauges with Cycles-baked metal textures; involute gears generated in Three.js r160.