Presets
Playback
Apparatus
Model checks
The science
What is modelled
A tower crane is a balance. The load hangs out on the jib and the counterweight balances it on the other side. The moment limiter allows less load at larger radius, and the base must resist the net overturning moment, including wind. When the trolley accelerates, the load on its rope behaves as a pendulum and swings. Input shaping splits the trolley command into two parts timed half a pendulum period apart so that the two swings cancel.
Equations
- Load chart
mmax(r) = min(mcap, Mrated / r). - Net moment about the tower axis
M = m r + M0, where M0 collects the jib, counter-jib and counterweight (negative: balanced to the rear). - Tipping safety factor
SF = W b / 2 / (g M + Mwind)with base weight W and base width b; wind momentMwind = ½ ρ Cd A v² h. - Pendulum with a moving support
θ'' = − (g/L) sinθ − (a / L) cosθ − 2 ζ ω0 θ', small-angle periodT = 2π √(L/g). - Large-amplitude period
T = 4 √(L/g) K(sin(θ0/2))with the complete elliptic integral K. - ZV input shaper: impulses
1/(1+K)at 0 andK/(1+K)at Td/2,K = exp(−ζπ/√(1−ζ²)).
Checks run in the page
- The small-amplitude pendulum period against
2π√(L/g). - The period at 30 degrees amplitude against the elliptic-integral formula.
- The residual sway after a move with and without the shaper.
- The tipping radius from bisection against the closed form.
Honest simplifications
A point-mass load on a rigid massless rope, a rigid crane, no rope length change during the move, no load rotation, wind acting only on the jib and the load as a constant force, and the load chart and base data are round teaching numbers, not those of a real crane. Real cranes follow the load chart and wind limits in the manufacturer's manual.
What to try
- Press Long rope, no shaper, and watch the load keep swinging after the trolley stops.
- Press Shaper on and see the sway almost vanish for the same move.
- Press Windy heavy lift and watch the tipping factor fall below 1.