Space elevator - 2D cable taper

Why a space elevator cable must widen towards geostationary orbit, and which materials make it possible.

Switch to 3D

Presets

Playback

Parameters

Model checks

The science

Effective gravity along the cable

A cable that co-rotates with the planet at angular speed ω feels, per kilogram, gravity GM/r² downwards and centrifugal acceleration ω²r upwards. The two cancel at the synchronous radius rs = (GM/ω²)1/3 (42 164 km from the centre of the Earth). Below rs the cable is pulled down and the tension must increase with height; above it the centrifugal term pulls up, so the cable can be held by a counterweight or by its own mass.

Constant-stress taper

If the working stress σ is the same everywhere, the cross-section must satisfy dA/A = (ρ/σ)(GM/r² - ω²r) dr, giving A(r)/A(R) = exp[(ρ/σ)(Φ(r) - Φ(R))] with Φ = -GM/r - ω²r²/2. For Earth the potential gap to the synchronous radius is about 48 MJ per kg, so the taper ratio is exp(48 MJ/kg / (σ/ρ)): fewer than ten for a cable with σ/ρ of tens of MJ/kg, but astronomically large for steel.

Honest simplifications: a spherical, non-wobbling planet and a cable in the equatorial plane; no payload, atmosphere, orbital debris, Coriolis sway, Moon or Sun gravity; the stress is a chosen working stress (with safety factor), not the breaking strength; the climber is a point.

What to try
  • Press Earth, steel: the taper ratio is ten to the power of more than a hundred, so the cable cannot exist.
  • Press Earth, carbon nanotube cable: the taper falls to a handful.
  • Open the third graph and find what specific strength gives a taper ratio of e (about 48 MJ/kg).
  • Try Mars: weaker gravity and a closer synchronous orbit mean a much easier cable.
Cable cross-section against altitude
Effective gravity against altitude
Taper ratio against specific strength