The science
Brakes turn the kinetic energy of the car into heat in the friction pair of rotor and pad. Stopping from 160 km/h (44 m/s) a 1500 kg car releases about 1.4 MJ; roughly 70 % goes to the front axle, so each front disc absorbs ~0.45 MJ in 5-6 seconds, a power of ~80 kW. A 9 kg iron rotor with c ≈ 500 J/(kg K) warms ~100 K per stop, and it cools in minutes, not seconds.
Lumped thermal model (one front disc):
C(T)·dT/dt = η·Pb − h(v)·Ac·(T − Ta) − εσAr·(T4 − Ta4)
Pb = 2μ(T)·N·Reff·ω (two pads), ω = v/Rw, η = 0.9 of the heat enters the rotor (the rest goes into pad and caliper), C = mr(450 + 0.28·T[°C]) J/K. Convection coefficient h(v) = 18 + 2.6·v0.9 W/m²K (rises with road speed v in m/s: air through the vanes), radiation with ε = 0.8.
Vehicle: m·dv/dt = −Fb − Fdrag − Froll + m g sinθ, Fb = 4·(2 μ N Reff/Rw) distributed 70/30 front/rear. The pedal sets the clamp force N = p·Nmax; the deceleration is limited by tyre grip at 1 g.
Fade: pad friction depends on temperature. Cold pads grip a little less; the optimum sits at 200-400 °C; above the compound's fade onset the resin and binders outgas and decompose, and μ falls. With the same pedal force the car now needs more distance, which means more heat in the next stop — a positive-feedback loop. Descents are the other trap: braking power is m g sinθ·v continuously and the rotor reaches a hot steady state Ta + P/(hA). Engine braking and a lower speed reduce the load.
Checks. (1) A headless stop is integrated and the brake work plus drag and rolling work is compared with the kinetic-energy change. (2) A hot rotor cools with constant parameters (no radiation) and is compared with the analytic exponential Ta + ΔT·exp(−t/τ), τ = C/(hA). (3) A constant brake power run reaches the analytic steady state Ta + ηP/(hA).
Honest simplifications. Single lumped temperature (no thermal gradients, coning or hot spots), no pad temperature model, no brake-fluid boiling or vapour lock (the second fade mechanism, not modelled), no ABS or brake balance shift, constant tyre grip, no wheel-speed dependence of μ. The μ(T) curves are smooth, qualitative shapes for a street, a sport and a racing compound; real curves vary by lot. Not for engineering decisions.