Electromechanical conversion · 2D laboratory

Piezoelectric cantilever energy harvester

Drive a flexible beam, harvest its vibration through a bonded piezoelectric layer, and find how frequency and electrical load shape the power output.

Single-mode model
01 / Cantilever cross-section
Scaled motion · deflection is exaggerated for visibility
Tip displacement—µm peak
Load voltage—V RMS
Electrical power—µW
Natural frequency—Hz
Independent check · Peq / Pload—

Frequency response

Load power · µW

Steady-state waveforms

Normalised amplitude
The science · equations and assumptions
m x¨ + cₘ x˙ + kx + θv = −m aᵦ sin(ωt)
Cₚ v˙ + v/R − θx˙ = 0

The first equation describes the first bending mode of a cantilever with a proof mass. The second describes a piezoelectric element connected to a resistive load. The displayed response is the steady-state harmonic solution of these coupled equations.

  • Textbook: linear mass–spring–damper dynamics and a linear piezoelectric coupling term.
  • Illustrative: modal mass, stiffness, coupling and capacitance represent an equivalent device, not a measured product.
  • Scaled: beam deflection is enlarged; the drawing is not a geometric finite-element model.
  • Assumes one bending mode, constant material properties, sinusoidal base acceleration and an ideal resistor. Nonlinearities, dielectric loss and higher modes are omitted.

Independent check: a scalar equivalent-damping calculation produces P_eq, shown beside the circuit-derived P_load. Their agreement checks the coupled harmonic solution.

Made with 🤖 ChatGPT