Electromechanical conversion · 3D assembly

Piezoelectric cantilever assembly laboratory

Explore the fixed clamp, flexible beam, bonded piezoelectric patch and proof mass while the first bending mode responds to base vibration.

Three.js r160
02 / Explorable assembly
Orbit to inspect · drag to rotate · scroll to zoom
Fixed clampPiezo layerProof mass
Tip displacement—µm peak
Load voltage—V RMS
Electrical power—µW
Natural frequency—Hz
Independent check · Peq / Pload—
The science · equations and assumptions
m x¨ + cₘ x˙ + kx + θv = −m aᵦ sin(ωt)
Cₚ v˙ + v/R − θx˙ = 0

The first equation describes the first bending mode of a cantilever with a proof mass. The second describes a piezoelectric element connected to a resistive load. Both 2D and 3D laboratories use the same steady-state harmonic model and default parameters.

  • Textbook: linear mass–spring–damper dynamics and reciprocal piezoelectric coupling.
  • Illustrative: modal parameters represent an equivalent device, not a measured product.
  • Scaled: beam motion and component proportions are enlarged for inspection.
  • Assumes one bending mode, constant properties, sinusoidal base acceleration and an ideal resistor. Higher modes, nonlinearities and dielectric losses are omitted.

Independent check: a scalar equivalent-damping calculation produces P_eq, shown beside the circuit-derived P_load. Their agreement checks the coupled harmonic solution.

Made with 🤖 ChatGPT · Three.js