☼MySimulator · Scientific simulation family

Photovoltaic Cell Engineering

8 INTERCONNECTED LABS
Electrical engineering · Semiconductor physics · Renewable energy

From a photon striking silicon to a controlled solar array.

Investigate photovoltaic conversion with a shared, physically grounded single-diode model. Change irradiance, cell temperature and array topology, then carry the same experiment through eight complementary laboratories.

Shared scientific engine

One model · consistent parameters · transferable scenarios

All modules use the same implicit single-diode I–V equation with irradiance and temperature dependencies. Scenarios are shared locally between module pages and can be exported/imported as JSON. The model assumes uniform illumination and matched cells; partial shading and detailed semiconductor transport are outside this family’s scope.

LAB 01

Cell Cross-section Laboratory

Explore photon absorption, the p–n junction, charge separation and the external circuit.

Open laboratory →
LAB 02

Analytical Graph Laboratory

Inspect I–V and P–V characteristics, operating points, open-circuit voltage and MPP.

Open laboratory →
LAB 03

Experiment Laboratory

Run a time-domain irradiance experiment with clear-sky, cloud-pulse and sunrise-ramp profiles.

Open laboratory →
LAB 04

Comparison Laboratory

Compare reference, cloudy, hot-bright and cool-bright scenarios on common axes.

Open laboratory →
LAB 05

Mathematical Model Explorer

Test sensitivity to series resistance, shunt resistance, diode ideality and saturation current.

Open laboratory →
LAB 06

MPPT Challenge Mode

Operate a variable-voltage load with a perturb-and-observe maximum power point tracker.

Open laboratory →
LAB 07

Data Analysis & Report

Generate synthetic I–V measurements, inspect samples, calculate performance and export CSV.

Open laboratory →
LAB 08

Series–Parallel Array Designer

Configure series cells and parallel strings, then inspect voltage, current and power scaling.

Open laboratory →
Made with 🤖 ChatGPT