An OTEC plant pumps cold deep water up a long Cold-Water Pipe (CWP) to condense the working fluid of a Rankine cycle driven by warm surface water. The CWP is the single most expensive and most sensitive component: a narrow, fast pipe costs less steel but wastes power on friction; a wide, slow pipe recovers more net power but costs more to build. This simulator plots that exact trade-off.
Flow: A = πD²/4, Q = vA, ṁ = ρQ (ρ = 1025 kg/m³ seawater)
Gross: Q_th = ṁ · c_p · ΔT_hx (c_p = 4000 J/kg·K, ΔT_hx = 3°C heat-exchanger approach)
η_Carnot = ΔT / T_warm, η_actual ≈ 0.30 · η_Carnot
P_gross = η_actual · Q_th
Friction: Re = ρvD/μ, f ≈ 0.316 / Re^0.25 (Blasius correlation, turbulent flow)
ΔP = f (L/D)(ρv²/2)
Pumping: P_pump = ΔP · Q / η_pump (η_pump = 0.85)
Net: P_net = P_gross − P_pump
- Diameter D — friction loss falls steeply with diameter (roughly ∼1/D⁵ for fixed velocity), which is why real CWPs are 3–11 m wide despite the extra steel.
- Velocity v — more flow means more heat delivered, but pumping power grows with v³, so past a point every extra litre/second costs more than it earns.
- Depth L — a deeper pipe reaches colder water (bigger usable ΔT in real plants) but also adds friction length; here L only affects pumping loss to isolate the diameter/velocity trade-off.
- ΔT — the Carnot ceiling on thermal-to-electric conversion; OTEC's whole appeal and whole limitation is that this gradient is only 15–24°C, so η_actual rarely exceeds 2–3%.
Push D too small at a given v and P_net turns negative — the plant would spend more electricity pumping seawater than the temperature gradient can ever give back, which is exactly why CWP sizing is treated as OTEC's primary engineering bottleneck rather than an afterthought.