PEM fuel-cell stack: bipolar plates, exploded cell and polarization curve

Blender-built stack, tank and lamp with an exploded membrane-electrode cell, driven by the Nernst / Butler-Volmer / Nafion model of the 2D page.

Switch to 2D

Presets

Playback

Operating conditions and stack

Camera

Layers

Quality

Model check

The science

What you are looking at

On the left of the bench a polymer-electrolyte (PEM) fuel-cell stack, hydrogen tank and lamp, all Blender 5.2 models (graphite bipolar plates with serpentine flow channels, aluminium end plates, copper collectors, tie rods). On the right (camera Cell detail) one repeat unit is pulled apart: anode plate, gas-diffusion layer, anode catalyst, membrane, cathode catalyst, gas-diffusion layer and cathode plate. Particles show the chemistry: H₂ runs along the anode channel and splits at the catalyst, the protons cross the membrane, the electrons take the wire through the lamp, and at the cathode O₂, H+ and e− make water. The lamp brightness follows the stack power. The animated particle rate is proportional to the current, but each dot stands for a huge number of real molecules.

Model

Reversible voltage E = E0(T) + (RT/2F) ln(pH2√pO2) with E0 = −(ΔH − TΔS)/2F (1.229 V at 25 °C). Losses: activation (RT/αF) asinh[(i + in)/(2i0)] (Tafel at larger i), ohmic i(t/σ + Rc) with the Springer (1991) Nafion conductivity, mass transport −(RT/2F) ln(1 − i/iL). Hydrogen use is N I M/(2F) and the waste heat N I (Etn − V) with Etn = 1.481 V (higher heating value).

Channel pressure drop

The anode channel is drawn as one serpentine of 7 passes. For the readout it is treated as a 1.0 × 0.8 mm duct whose length is the scene polyline length scaled to the chosen cell area; laminar flow in a rectangular duct gives Δp = 2 (fRe) μ L v / Dh² with fRe ≈ 57, hydrogen at 1.5 times stoichiometry. It is an illustration of flow-field design, not a plate design.

Honest simplifications

Uniform current density, steady state, constant lumped i0 and α, no flooding or dry-out dynamics, no temperature gradient, no compressor or humidifier losses. Only the first 16 cells are drawn when the stack has more. The plate geometry is schematic (not to the real 1 mm channel scale). Hydrogen is flammable: this is an educational model, not an engineering or safety tool.

Checks run in the page

  • The five checks of the 2D page: E0 and Etn from ΔG and ΔH, Tafel slope, Nernst pressure doubling, maximum-power point, Faraday and energy balance.
  • The scheduler that moves the particles is run for 1000 s at two currents: the proton crossings per second must scale like the current.
  • The bipolar plate bounding box is read from the Blender mesh (1 × 1 × 0.1), the serpentine centre-line length must equal 7·0.80 + 6·0.10, all channel points must lie inside the plate, and the channel pressure drop is recomputed from that length.

Credits

Blender 5.2 hardware with Cycles-baked graphite, aluminium and steel textures (Draco GLB); Three.js r160.

Loading model...
Loading Blender model...
Polarization curve and power density
Voltage losses and efficiency vs current
Stack power and waste heat
Run time on 1 kg of hydrogen
Made with 🟠 Blender · Three.js