Presets
Playback
Parameters
Camera
Layers
Quality
Model check
The science
What is modelled
A belt-driven Van de Graaff generator: a rubber belt carries sprayed charge up a insulating column to a hollow metal dome. Inside the dome the charge moves to the outer surface, so the dome can keep gaining charge. Three losses fight the belt: leakage through humid air, corona discharge from the surface, and a spark to a grounded sphere once the gap voltage is reached. The page integrates the dome voltage in time and draws every effect on the Blender-built bench.
Equations
- Capacitance of the dome:
C = 4πε0R + Cstray(sphere 16.7 pF at R = 15 cm). - Belt current:
I = σ w v(surface charge density times belt width times belt speed). - Charging:
C dV/dt = I − V/Rleak − Icorona(V). Without corona the solution isV(t) = I Rleak (1 − e−t/RC). - Field at the surface:
E = V/R = Q/(4πε0R2); outside the domeE(r) = V R / r2(shell theorem). Dry air breaks down nearEb ≈ 3 MV/m, so a small dome cannot hold as much voltage as a large one:Vmax ≈ Eb R. - Spark gap:
Vb(d) = Eb d / (1 + d/(R + r)), an empirical sphere-gap correction; the stored energy isW = ½ C V2. - Hanging foil balls on threads: charge
q = 4πε0 a V; the thread angle follows from the torque balanceq E(r) (x cosθ + z sinθ)/r = m g sinθ.
Checks run in the page
- Numerical integration of the charging equation against the exponential closed form.
- Direct Coulomb summation over thousands of surface patches against the point-charge field outside the dome (shell theorem).
- Energy accounting: work done by the belt equals leakage plus corona plus stored energy.
Honest simplifications
The leakage resistance follows a simple exponential in humidity, the corona current is a steep power law that caps the voltage near 0.85 EbR, and the gap breakdown uses a smooth empirical formula, not a full streamer model. After a spark the dome keeps 8 percent of its voltage (the arc goes out when the field falls). The belt, rollers and charges are drawn slowed down for readability. The foil balls ignore their repulsion from each other and the table. This is an educational model at sea-level air; real machines differ in details such as humidity-dependent air, belt material and sharp points.
What to try
- Use the humid-day preset: the voltage stalls well below the spark voltage because the leak current equals the belt current.
- Compare the small and large dome presets: the large dome stores more energy per spark but needs longer to charge.
- Widen the gap to 40 cm: sparks stop and corona limits the voltage.
- Watch the hanging balls lift as the voltage rises, then fall back after a spark. Press the touch button to ground the dome.