Presets
Playback
Magnet and disc
Field strength, size and mass set the machine constant K = B R^2 / 2.
Electrical circuit
Set the battery to 0 V to turn the motor into a generator.
Shaft
A negative torque loads the motor; a positive torque cranks the generator.
Display
Real speeds are far too fast to see, so the picture is slowed down.
Layers
Model checks
The science
Why a plain disc works
Each free electron in the copper moves with the disc at speed v = w r. In an axial field B the Lorentz force per unit charge is v x B, pointing along the radius. Integrating across the disc gives a motional EMF between rim and axle: EMF = integral of w r B dr = B w R^2 / 2.
Motor and generator are the same device
With a circuit resistance Rc, battery Vs and EMF K w (K = B R^2 / 2) the current is I = (Vs - K w) / Rc. The radial current in the field feels a tangential force, giving the torque T = K I. The shaft obeys J w' = K I - b w + T_ext with J = m R^2 / 2. This is linear, so the speed relaxes exponentially to w_inf = (K Vs / Rc + T_ext) / (K^2 / Rc + b) with time constant J / (K^2 / Rc + b). Set the battery to zero and turn the shaft: the same K now produces a current that brakes you - the generator.
Power
Battery power Vs I splits into Joule heat I^2 Rc and mechanical power K I w; bearing friction takes b w^2 out of the mechanical share. The energy-balance check integrates these over the run.
Honest simplifications
Circuit inductance, brush contact drop, skin and eddy effects in the disc, the magnet field falling off with radius, and the field of the current itself are ignored. Real homopolar machines have tiny voltages (here fractions of a volt) and need very large currents; that is why they are used where heavy current is natural (pulsed power, ship propulsion experiments). The spin in the picture is slowed down so you can see it; all readouts are real values.
What to try
- Press Reverse the magnet: the disc spins the other way - torque is K I and K changes sign with B.
- Press Generator (hand crank): with no battery the current is produced by the EMF and the machine loads the shaft.
- Raise the loop resistance: the stall current drops and the no-load speed stays the same (it only depends on V and K).
- Run Short-circuit brake and watch the kinetic energy turn into Joule heat in the power graph.
- Double the disc radius at fixed battery: the no-load speed falls by 4 times since w_inf = 2 V / (B R^2).