Presets
Playback
Parameters
Layers
Model check
The science
What is simulated
Potash and rock salt are mined in rooms separated by square pillars of unmined rock that hold up everything above. The page treats one regular panel: it computes the weight of the overburden at the chosen depth, the stress this puts on each pillar, the pillar's strength and the resulting safety factor, the slow creep of salt that makes pillars shorten and rooms close, and the stress in the immediate roof over a room. In 3D a continuous miner works in one of the rooms; pillars change colour from salmon to red as their safety factor falls.
Overburden and pillar stress
The vertical stress at depth H is the weight of the rock above: σv = g Σ ρi di over four layers with densities of 2000 to 2600 kg/m3. With pillars of width p and rooms of width w the extraction ratio is e = 1 − (p/(p+w))2 and, by the tributary-area rule, each pillar carries σp = σv/(1 − e): every square metre of pillar holds up its own share of the roof plus the share over the neighbouring room.
Strength, long-term factor and creep
The pillar strength uses the Obert-Duvall form σs = σ1(0.778 + 0.222 p/h): squat pillars (large p/h) are stronger than the rock cube because they are confined. Salt creeps, so a long-term factor fLT is applied and the safety factor is SF = fLT σs/σp. Creep follows a Norton power law, dε/dt = A (σp/20 MPa)4.5, so the pillar height falls as h(t) = h0 exp(−ε̇ t) and the room closes by the same amount; shortening raises p/h and the strength.
Roof
The immediate roof is a 1.5 m beam clamped at both ends over the room width. Its own weight gives a peak tensile stress γ w2 / (2 tb) and a mid-span deflection q w4 / (384 E I), compared with a 3 MPa tensile strength.
Simplifications
- The tributary-area rule assumes an infinite regular panel with uniform load; edge pillars, barrier pillars, abutment stress, and the stress concentration around the panel are not modelled. Real mine design uses numerical models and monitoring.
- Strength values (unit strength 15 to 50 MPa, long-term factor 0.4 to 1, creep coefficient), the densities of the four layers and the 4.5 exponent are round figures of the right order for evaporite mines, not data for any one mine. The creep coefficient is a slider because it depends strongly on temperature and the salt.
- Creep is applied as vertical shortening at constant stress; lateral bulging, floor heave, roof fracture and time-dependent strength loss are not modelled. The 2 m height limit for the machine is an assumption.
- The miner is an animation; it does not change the layout.
Checks
Five boxes: the extraction ratio and the pillar stress from rasterising a plan of nine pitches; the layered overburden stress from a summation in 220 000 thin slices; the creep height from a Runge-Kutta solution of the same law; the roof beam peak stress and mid-span deflection from a finite-difference solution of the clamped beam equation against the closed forms.