Presets
Playback
Tool plate target
Each motor arm and its lower rod form a circle-sphere intersection. The target is reachable only where all three intersections exist within the motor limits.
Model checks
The science
What is modelled
Three identical arms, spaced 120 degrees apart, hold a tool plate with rods of equal length. For a given plate position each motor angle follows from where a sphere of rod length around the plate anchor meets the circle swept by the upper arm.
Equations
- Constraint
|elbow_i(theta_i) - anchor_i(p)| = L_lowerfor i = 1..3. - Inverse kinematics solves each arm in its radial-vertical plane; forward kinematics solves three sphere equations by damped Newton iteration.
- Workspace = set of plate positions with all three angles inside the motor limits.
Checks run in the page
- Inverse then forward kinematics returns the same point.
- All three rods keep their length.
- Three-fold rotational symmetry of the motor angles.
- Finite-difference Jacobians multiply to the identity.
Honest simplifications
The parallelograms are idealised as a tool plate that never rotates; joint clearances, rod mass, deflection and motor dynamics are ignored. Not a robot controller.
What to try
- Press Reach to the edge: the yellow dot hits the boundary of the blue region and is clamped.
- Lower the height: the reachable area changes, as the graph shows.
- Press Centre pick and see all three motors share the same angle.