Cement Decarbonization Levers: Clinker Ratio, Kiln Fuel and Carbon Capture (2D)

A flow sheet of a cement plant: pull the three levers (clinker ratio, kiln fuel, carbon capture) and watch the CO2 streams, the stacked emission bar and the net CO2 per tonne change.

Switch to 3D
Controls

Presets

Parameters

Model checks

The science

Where cement CO2 comes from. Most of the carbon dioxide is not from burning fuel. Heating limestone drives off CO2 in the reaction CaCO3 → CaO + CO2. With molar masses summed from atomic masses (CaO 56.08, CO2 44.01 g/mol) every kilogram of lime in the clinker releases 0.785 kg of CO2, so a clinker with 66 % CaO emits 0.66 × 0.785 = 518 kg of process CO2 per tonne, whatever fuel is burned. The kiln also needs heat: calcination alone takes ΔH = ΔHf(CaO) + ΔHf(CO2) − ΔHf(CaCO3) = +179 kJ/mol (about 2.1 GJ per tonne of clinker); real dry kilns use 3.0 to 3.5 GJ/t because they also heat the solids to 1450 C and lose heat.

Levers. (1) The clinker-to-cement ratio multiplies both process and fuel CO2, because blending in limestone, fly ash, slag or calcined clay (supplementary cementitious materials) means less clinker per tonne. (2) The fuel mix: kiln fuel CO2 is Q × [(1−a) EFfossil + a (1−b) EFalt]; biomass CO2 (share b of the alternative fuel) counts as zero because the plants took the same carbon from the air. (3) CCUS removes a fraction r of the whole flue-gas CO2 (process + fossil + biogenic) and needs about 0.12 kWh of electricity per kg captured, so the net result is net = P + F + (grinding + capture electricity) × g − r (P + F + B). Capturing biogenic CO2 can push the net below zero (bio-energy with CCS).

Numerical checks. The page re-derives the stoichiometry from the carbonate side, integrates the Arrhenius decomposition along the 60 m kiln with RK4 and a mesh-convergence test, compares the kiln heat with the enthalpy bound computed from formation enthalpies, brackets the fuel emission factors between methane (54.9 kg/GJ) and pure carbon (111.8 kg/GJ) combustion chemistry, and checks the model's lever sensitivities against hand-derived slopes.

Simplifications. One average plant; constant kiln heat per tonne of clinker (no change with alternative fuels' moisture or the drier needed); alternative-fuel and biomass emission factors (85 and 110 kg CO2/GJ) and the capture-plant electricity use are typical round numbers, not measurements; no transport, quarrying or concrete-use emissions; the kiln profile is an illustrative linear temperature rise. Not affiliated with any cement producer. Educational model, not an emissions inventory.

-
-
Made with 🟠 Blender