Structural Load Test

A beam model on knife-edge supports: stack mass on it, drag the load, see deflection, stress and the safety factor.

Presets

Playback

Material

Beam and load

Layers

Model check

The science

Model

Euler-Bernoulli beam on two knife-edge supports with a point load P = M g at a plus its own weight q = rho b h g. Closed forms: w(x) = P b x (L^2 - b^2 - x^2) / (6 E I L) (x ≤ a) and w = q x (L^3 - 2 L x^2 + x^3) / (24 E I); bending moment gives the tension-face stress sigma = M_max (h/2) / I, I = b h^3 / 12. Safety factor = strength / sigma. The bar colour along the tension face shows local moment relative to the yield moment.

Dropping the load

A suddenly applied load is modelled as a single damped mode (Rayleigh method with the static deflection shape): s'' + 2 zeta omega s' + omega^2 s = omega^2, with omega^2 = k / (M + mu int phi^2 dx). Undamped, the peak is exactly twice the static value; with damping 1 + exp(-pi zeta / sqrt(1 - zeta^2)). Stress and deflection follow the load factor quasi-statically.

Simplifications

Linear elastic, small deflections, rectangular section, no shear deformation, no lateral buckling, no local crushing at the load. Wood strengths are typical bending-strength values and vary a lot between boards; metal values are yield. When the safety factor falls below 1 the picture shows a crack but the model does not continue into plastic or brittle failure. Deflection is drawn magnified; thickness is to scale. This is a teaching model for small test pieces, not a design tool for real buildings.

Checks (run on load)

(1) a tridiagonal finite-difference solve of the beam equation matches the closed form; (2) Rayleigh frequency of the bare beam vs the exact (pi/L)^2 sqrt(EI/mu); (3) the time integrator reproduces the analytic overshoot. Bench, knife edges and weights were rendered in Blender (Cycles).

Bending moment M(x)
Deflection w(x)
Response to a dropped load
Made with 🟠 Blender