Presets
Playback
Truss type
Geometry and tubes
Tube diameters set area, inertia and slenderness of every member.
Material
Loading
The load factor multiplies the vehicle; the pushover button ramps it up until collapse.
Layers
Model checks
The science
One solver, two views
The bridge is a plane pin-jointed truss: every member carries only an axial force N. The stiffness matrix is assembled from k = EA/L along each member axis, supports are removed and the joint displacements solve K u = f. The member force follows from the stretch, N = EA/L (ub − ua)·e. Dead load (member weight and deck) is applied first; the vehicle is a generic three-axle load symbol placed at the slider position and multiplied by the load factor.
Why members fail
In tension a tube yields at Pt = σy A. In compression it fails earlier by buckling: slender tubes follow Euler, Pcr = π2EI/(KL)2, stocky ones the Johnson parabola. The pushover removes the first member that reaches capacity, re-solves the structure and continues; a determinate truss collapses at once, a redundant one redistributes force. The influence line is the member force produced by a unit load at each deck joint.
Honest simplifications
Straight, perfectly pin-ended members, small displacements, no gusset plates, connection or lateral-torsional failure, no dynamic or impact factor, and the modular panel is a generic illustrative module, not manufacturer data. Educational model, not a design check.
What to try
- Pick Howe 36 m and press Load to failure: the long compressed diagonals buckle first.
- Add counter-diagonals to Pratt: the bridge survives its first failure and redistributes load.
- Click a member to see its influence line; the peak shows the worst vehicle position.
- Pin both supports and raise the temperature: stress appears with no vehicle at all.