Each pallet rests across two parallel step beams, so each beam carries half the pallet weight, spread over the pallet width. The beam is a hollow rectangular section with stiffness EI (E = 210 GPa for steel; I from the wall thickness) hooked into the uprights by end connectors that resist rotation a little. The bay is checked against a serviceability limit (sag no more than L/200) and a strength limit (bending stress below fy / 1.4).
I = (b h^3 - (b-2t)(h-2t)^3) / 12 section modulus Z = I / (h/2)
EI v'''' = w(x) finite elements, pinned vertically, end spring k = 2 EI f / (L (1 - f))
full-span load: v_max = w L^4 (5 - 4 f) / (384 EI) (f = 0 pinned, f = 1 fixed)
M_max = max|M|, sigma = M_max / Z, safe load = min(L/200 limit, fy/1.4 limit)
both responses are linear in the load, so the safe mass is the present mass x limit / response
- Span is cubed twice - deflection grows with L^4 but the limit only with L, so a longer bay needs a much deeper beam; doubling the section depth gives about 6-8 times the stiffness.
- Connectors help - fixity f moves moment to the ends: midspan deflection falls by the factor (5 - 4f)/5, which is why the end-hook quality matters; the sim lets you see the effect, a real value comes from connector tests.
- Same model in both pages - one shared finite-element routine; the checks compare it with closed forms, a numerical integration of the section and a statics balance.
- Honest simplifications - elastic linear beam, no local buckling, lateral-torsional buckling, shear deflection, pallet-board flexibility, beam self-weight, connector slip, upright flexibility or load factors from a design code; the stress limit uses one factor 1.4. This is a teaching model, not rack design or a load plate: always use the manufacturer's load tables.