Structures Elevation Lab

2D companion of the London landmarks structures explorer: four stops drawn in elevation with force arrows, the line of thrust, base stress and spoke tension.

Switch to 3D

Presets

Playback

Stop and loads

Options

Model checks

The science

What is modelled

Four stops of the 3D structures lab, drawn in elevation: a stone arch bridge, a masonry clock tower, a cable-spoked giant wheel and a suspension cable. Each stop uses exactly the same physics.js as the 3D page, so the numbers agree. Dimensions are round model values (36 m arch, 96 m tower, 64-spoke wheel, 60 m cable span), not the real landmarks.

Equations

  • Arch (three-hinged idealisation). VA = wL/2 + P(1 - a/L); zero moment at the crown hinge gives H = [VAL/2 - wL²/8 - P max(0, L/2 - a)] / f, and H = wL²/(8f) for a uniform load alone. The line of thrust is yt = M(x)/H; stone carries no tension, so it must stay inside the middle third (e ≤ t/6); beyond t/2 a hinge forms.
  • Tower (Euler-Bernoulli cantilever). δ = qH&sup4;/(8EI), M0 = qH²/2, σ = N/A ± Mc/I, f1 = (1.875²/2π) √(EI/(m'H&sup4;)), with q = ½ρv² Cd b.
  • Wheel. Spokes are springs that cannot push: Ti = max(0, T0 ± u cos αi), with u chosen so that Σ Ti cos αi = P. With no slack ΔT = 2P/n; slack starts near P = nT0/2.
  • Cable. Th = wL²/(8f), Tmax = √(Th² + (wL/2)²); the catenary (cable weight) and the parabola (deck load) differ by millimetres at these sags.

Checks run in the page

  • Arch: closed-form H against a 200-node funicular solve, the parabola test, vertical equilibrium.
  • Tower: deflection and frequency against numerical integration and a Rayleigh quotient, base-section stress summed over 600 strips.
  • Wheel: vertical and horizontal equilibrium of the spoke forces, the linear rule 2P/n.
  • Cable: H against a nodal solve, cable length against 4000 chords, the force triangle at the tower.

Honest simplifications

Linear elastic 2D models, uniform materials, one load at a time, no soil, crowd dynamics or temperature. The tower sway is drawn x600 and the gust is an illustrative +-35 % oscillation. This lab is independent and not affiliated with any building owner or operator; it is not engineering advice.

What to try
  • On the arch press Flat ring, light fill and drag the vehicle: the orange line of thrust leaves the dashed middle third as the load nears the quarter span.
  • On the tower press Gale, thin walls: the deflection and the windward stress climb, f1 falls, yet the leeward edge stays in compression because e stays inside the kern b/6.
  • On the wheel press Overloaded, slack spokes: the spokes above the hub turn grey and dotted and the rise in tension is no longer 2P/n.
  • On the cable halve the sag ratio and read the horizontal pull double.
Thrust-line offset
Worst offset
Thrust
Allowed load