Canal Lock Long Section

2D companion of the English canal lock: the chamber in cross-section with every water level on one gauge, the paddle flow, the boat surge and the water saved by side ponds.

Switch to 3D

Presets

Playback

Lock and water

Model checks

The science

What is modelled

A pound lock lifts a boat by moving water, not the boat. This page is the cross-section of the same state machine as the 3D lock: the boat enters, the gate closes, water flows through paddles until the chamber level meets the other pound within 2 cm, the other gate opens and the boat leaves. Side ponds store part of the water so each lockage draws less from the upper pound.

Equations

  • Flow through a paddle (sluice): Q = Cd a √(2 g h), with h the level difference across it.
  • Chamber of area A = L B: dz/dt = Q/A, so the head falls as √h and the fill time is T = 2A(√H − √ε) / (Cd a √(2g)).
  • Energy dissipated in the paddle: ρ g ∫ Q h dt = ρ g A (H² − ε²)/2 - the lift potential energy is thrown away as turbulence unless a side pond catches half of it.
  • Side ponds of area ratio r: each stage equalises two tanks, and with large ponds the saving tends to n/(n+1).
  • Gate load: F = ½ ρ g B (d1² − d2²); mitre gates carry it as compression along the leaves, F / (4 sin θ) each.
  • Jet surge on the boat: inlet momentum flux ρ Q u times a loss factor per inlet type, compared with 2 % of the boat weight as an illustrative comfort limit.

Checks run in the page

  • RK4 integration against the closed-form fill time.
  • A full state-machine lockage (instant valves) against the staged closed forms, with a volume balance.
  • Dissipated energy against the closed form.
  • Gate load by summing the pressure over 4000 slices.
  • Large-pond saving against n/(n+1).

Honest simplifications

Constant discharge coefficient, still-water pounds, rigid gates, and a comfort limit that is illustrative rather than a standard. Real culverts have a time-varying Cd, and surge in a chamber depends on the boat position and hull shape. The numbers match the 3D page because the same module computes both.

What to try
  • Press Narrow lock, 2 side ponds and watch the pond gauges at the right: the chamber level climbs in steps and the lockage draws about 56 % less water from the upper pound.
  • Drop the paddle opening time to 0 and raise the paddle area (Quick and rough): the flow peaks, the surge arrow turns red and the boat is pushed against the limit.
  • Halve the paddle area and compare the level plot with the fill-time prediction: the time doubles, the energy lost does not change.
Chamber level through the lockage
Flow through the paddles
Jet surge force on the boat
Water per lockage against number of side ponds