Beam Bending, Side View

2D twin of the 3D beam: the same Euler-Bernoulli finite-element solver and checks, drawn in side view with Blender-rendered parts so the shear and moment diagrams sit right under the bending beam.

Switch to 3D

Presets

Playback

Loads and span

Click the beam to move the point load. Deflection is exaggerated so you can see it; the factor is printed on the canvas.

Support condition

Beam section and material

Dynamics

Model checks

The science

Euler-Bernoulli bending. For a slender beam, EI w''''(x) = q(x), with curvature w'' = M/EI, shear V = dM/dx and bending stress σ = M y / I. Plane sections stay plane and perpendicular to the neutral axis. The page solves this with 100 cubic Hermite finite elements (exact for the cubic fields produced by point and uniform loads), then rebuilds shear and moment from statics (reactions and loads to the left of each section), so moment and curvature are two independent routes to the same quantity.

Closed forms used as checks. Simply supported, centre load: δ = P L³/48EI. Cantilever, uniform load: δ = w L&sup4;/8EI, root moment wL²/2. Fixed-fixed, uniform load: δ = w L&sup4;/384EI, end moment wL²/12. Propped cantilever: roller reaction 3wL/8. The Maxwell reciprocity theorem (deflection at B from a load at A equals deflection at A from the same load at B) and the beam fundamental frequency f1 = (π/2L²) √(EI/ρA) are also tested.

Dynamics. The load step is treated as a single-degree-of-freedom oscillator in the first mode, q'' + 2ζωq' + ω²q = ω², with ω from the Rayleigh quotient uTKu / uTMu (consistent mass matrix). A suddenly applied load gives a peak 1 + e-πζ/√(1-ζ²) times the static value, so almost 2 when undamped. Motion is shown in slow motion; the real frequency is in the readouts.

Honest simplifications. Linear elastic material and small deflections only: no yielding, no cracking of concrete (plain concrete would crack at about 3 MPa; real beams carry steel bars), no lateral-torsional buckling, no shear deformation (Timoshenko effect; the readout estimates its size relative to bending, and it matters when span/depth falls below about 10). Section properties of the I-beams are computed from a rectangle idealisation without root fillets, so they differ a few percent from catalogue values. Timber is treated as isotropic. The 3D beam depth is drawn at a fixed size whatever the span, and deflections are exaggerated for visibility (the exaggeration factor is shown).

What to try
  • Press Cantilever, same load: with the same load the tip deflects 16 times more than the centre of the simply supported beam (the check panel quotes the closed form).
  • Double the span: deflection grows as L3 for the point load and L4 for the distributed load.
  • Press Drop load suddenly: the peak reaches almost twice the static value; raise the damping to see it shrink.
  • Click on the beam to move the point load there.
Deflection w(x)
Shear force V(x)
Bending moment M(x)
Suddenly applied load: dynamic factor
Made with 🟠 Blender