← 🧪 Chemistry

🧪 Adhesive Cure Chemistry

Sets the Arrhenius reaction-rate constant for the epoxy-amine step-growth cure.
Mechanism: Step-growth (crosslinking)
Cure time: 0.0 s
Rate constant k: —
Conversion x: 0.0%
Network state: Liquid (pre-gel)
Crosslink density: 0.00
Modulus: ~0 MPa
Elasticity: — (liquid)
Drag — rotate · Scroll — zoom

🧪 Adhesive & Coating Cure Chemistry: Epoxy Crosslinking vs. Cyanoacrylate Polymerization

Watch two real adhesive-curing mechanisms side by side: two-part epoxy resin crosslinking with an amine hardener into a 3D thermoset network, and cyanoacrylate superglue undergoing fast anionic chain polymerization. Control cure temperature for the epoxy branch and watch conversion, crosslink density, modulus and elasticity update live as bonds form.

🔬 What It Demonstrates

Epoxy resin (2 reactive sites per molecule) and an amine hardener (4 reactive N–H sites per molecule) react step by step, obeying second-order step-growth kinetics with an Arrhenius-controlled rate constant. Below roughly 58% conversion the sample is still a liquid; past that gel point a single molecule spans the whole volume and it becomes a solid thermoset whose stiffness rises and elongation falls as crosslink density increases. Cyanoacrylate instead polymerizes by anionic chain growth, initiated almost instantly by trace surface moisture, producing long linear chains and a rigid, brittle solid within a second or two — largely independent of temperature.

🎮 How to Use

Pick an adhesive type to switch the active experiment. For epoxy, drag the cure-temperature slider (5–90°C) to speed up or slow down the Arrhenius reaction rate. Press Start curing to begin the bond-forming animation (press again to pause), and watch conversion, crosslink density, modulus and elasticity update live in the stats panel. Reset reseeds unreacted monomers and clears every stat.

💡 Did You Know?

Superglue won't harden inside a sealed, bone-dry container because its anionic chain reaction needs the trace hydroxide ions that ordinary surface moisture supplies to get started — which is also why breathing lightly on a joint or using an activator spray makes it set even faster.