Alunite Calcination in a Rotary Kiln: Dehydroxylation, SO3 Release and Potassium Sulfate Leach

Ore travels down a tilted rotating kiln: first the hydroxyl water leaves, then aluminium sulfate decomposes; the calcine is leached and potassium sulfate crystallises.

Switch to 2D

Presets

Playback

Parameters

Camera

Layers

Quality

Model check

The science

What is modelled

Alunite, KAl3(SO4)2(OH)6, is an ore of potassium and aluminium. It is calcined (roasted) in a long rotating kiln that is tilted a few degrees, so the ore creeps from the cold feed end to the hot end where a burner fires. On the way it passes two thermal steps, then the calcine is leached with hot water to dissolve the potassium sulfate, which crystallises on cooling, leaving an alumina-rich residue. The page marches a parcel of ore through the kiln with a chosen temperature profile and reads off the conversions, the products per hour and the leach and crystallisation balance.

Equations

  • Stage 1 (dehydroxylation): 2 KAl3(SO4)2(OH)6 → K2SO4 + Al2(SO4)3 + 2 Al2O3 + 6 H2O. Stage 2 (sulfate decomposition): Al2(SO4)3 → Al2O3 + 3 SO3. The overall solid loses 42 % of its mass when both go to completion.
  • Kinetics, first order in the remaining reactant: dX1/dt = k1(T)(1 - X1), dX2/dt = k2(T)(X1 - X2), with k(T) = k(Tref) exp[-(E/R)(1/T - 1/Tref)].
  • Residence time in a rotary kiln (Sullivan, Maier and Ralston correlation): t = 1.77 √θ L / (s D n) with the dynamic repose angle θ in degrees, the slope s in degrees, the speed n in rpm.
  • Leach: dissolved K2SO4 mass = solubility(T) × water; the crystals after cooling are the dissolved mass minus what the cooler liquor can still hold (handbook solubility table, 7.4 g/100 g at 0 C to 24.1 g/100 g at 100 C).

Simplifications and honest limits

  • The activation energies and the half-times (8 min at 600 C for stage 1, 15 min at 780 C for stage 2) are illustrative values of the right order of magnitude, not fitted to a specific ore. The real temperatures depend on the ore, the particle size and the atmosphere.
  • The solids temperature profile is a chosen curve, not the result of a heat balance with the gas, and no fuel use is computed. The residence-time formula is an empirical correlation, accurate to perhaps 30 percent. The bed is plug flow without axial mixing.
  • SO3 is shown as it leaves; in a real plant it partly splits into SO2 and O2 at these temperatures and is scrubbed or turned into acid. Impurities such as iron and silica are lumped into the inert quartz.
  • Undecomposed aluminium sulfate would dissolve in the leach water; the page reports it but does not model that solution chemistry or the ammoniacal leaching shown on the 2D page.
Loading model...
Loading Blender model...
Conversion and temperature along the kiln
Conversion against peak temperature
Potassium sulfate solubility against temperature
Made with 🟠 Blender · Three.js