A continuous stirred-tank reactor (CSTR) is fed with reactant A, which turns into B by a first-order exothermic reaction. The tank is perfectly mixed, so its outlet equals its contents. A jacket with cold water removes heat. Heat generation rises steeply (Arrhenius) and then saturates when A runs out, while heat removal is a straight line in temperature. A saturating curve and a line can cross three times: a cold, barely reacting state, a hot fully reacting state and an unstable one in between. This is the classic van Heerden / Aris picture behind ignition, extinction and runaway.
mass: dx/dt = k(T)(1 - x) - x/tau x = conversion of A, k = kref exp(E (1/Tref - 1/T))
energy: dT/dt = (T0 - T)/tau + dTad k(T)(1 - x) - a (T - Tc) a = UA/(rho cp V)
steady: x = tau k/(1 + tau k)
G(T) = dTad x(T)/tau (generated) R(T) = (T - T0)/tau + a (T - Tc) (removed) G = R
stable if trace J < 0 and det J > 0 (J = Jacobian of the two equations)
- Residence time - longer tau gives more conversion per pass but weaker feed cooling; it moves the S-curve.
- Coolant temperature - raise it and the reactor jumps hot at the ignition point; lower it and it falls back only at a lower extinction point (hysteresis). Try "Warm coolant" then "Cold coolant".
- Jacket strength and feed strength - more cooling or a weaker exotherm removes the hot state; the opposite removes the cold one. Bistability needs the removal line to cut the S-curve three times.
- Cold start / Hot start / Kick - the same inputs lead to different final states depending on where the reactor starts; a kick past the unstable state ignites it.
- Same model in the 2D twin - one shared physics module; the 3D page and the plan view only draw it. The 2D twin is Canvas drawing without Blender renders.
- Honest simplifications - one first-order reaction, constant density and heat capacity, a jacket at one fixed temperature (no coolant dynamics), no control loop and no safety design. Parameters are illustrative, not data of a real process. A teaching model, not a design or safety tool.