Grain Winnowing Lab (3D)

A combine cleaning-shoe test rig: chaffer, fan, air duct, bins and grain tank. Sort wheat from chaff by terminal velocity.

Switch to 2D

Presets

Playback

Air

Crop

Rig

Camera

Layers

Quality

Model check

The science

What is modelled

Material leaves the chaffer sieve of a combine harvester's cleaning shoe: plump wheat kernels, shrivelled kernels, short straw pieces, chaff and dust. A fan blows an air stream up and to the rear. Each particle is integrated through that stream with quadratic air drag; where it lands decides whether it ends in the clean-grain trough, the tailings return or is blown out of the machine. Particles are drawn about 3 times larger than real ones and are a sample of the feed, not a full flow.

Equations

  • Equation of motion in the air stream: m dv/dt = m g − ½ ρa (CdA) |v − u| (v − u), with the air velocity u = U (cos θ, sin θ) uniform in the cleaning zone (ρa = 1.2 kg/m3).
  • Terminal velocity in still air: vt = √(2 m g / (ρa CdA)). A particle with vt below the vertical air component U sin θ is lifted and carried rearward.
  • Kernel size and moisture: m ∝ d3, CdA ∝ d2, so vt ∝ √d; wet grain gains mass m = m14 (1 − 0.14)/(1 − w) and falls faster.
  • Class spread: each particle's terminal speed is multiplied by exp(σ z), z a standard normal number, to represent kernel-to-kernel variation.
  • Bins by landing position x: clean grain trough x < xc, tailings return xc ≤ x < xl, loss x ≥ xl. Grain loss = grain mass in the loss bin / total grain; purity = grain mass / total mass in the clean trough.

Checks run in the page

  • Terminal velocity of every class from a 40 s numerical drop in still air equals the analytic formula.
  • No-drag limit: a particle released with a chosen horizontal speed lands where v √(2h/g) says.
  • Mass balance: the clean, tailings and loss bins and the landing histogram all sum to the mass of the feed sample.

Honest simplifications

  • The air field is uniform in the cleaning zone, with no turbulence, no jet decay, no sieve flow resistance and no particle collisions or entrainment in a thick mat. The chaffer is treated as a release plane (the sieve opening itself is not modelled); class properties (mass, CdA) are round numbers chosen to give terminal velocities typical of wheat (about 9 m/s), light kernels, short straw (4-5 m/s) and chaff (2-3 m/s), not measurements of one crop. Real losses also happen over the straw walkers and in the rotor. The percentages are for the sample, not a field-calibrated machine performance.

What to try

  • Sweep the air speed and watch the two curves cross: too little air leaves chaff in the clean sample, too much throws grain out the back.
  • Raise the air angle: more lift for the same speed, less throw, so the loss rises sooner.
  • Wet grain (25 %) or large kernels fall faster; small kernels get lifted.
  • Move the tailings board to choose how much light grain returns for re-threshing.
Loading model...
Loading Blender model...
Where each class lands
Loss and impurity vs air speed
Terminal speed of each class
Made with 🟠 Blender · Three.js