Turbojet Spool

2D twin of the 3D jet-engine turbine: the compressor and turbine share a shaft, and any power imbalance accelerates or slows the spool.

Presets

Playback

Fuel setting and flight

More fuel raises the turbine inlet temperature. The turbine then delivers more than the compressor needs and the spool speeds up until the compressor work grows to match.

Model checks

The science

What is modelled

A single spool turbojet with a compressor whose pressure ratio rises with the square of spool speed, a combustor set by the turbine inlet temperature, a choked turbine with fixed expansion ratio and a convergent nozzle. The turbine expansion is calibrated so that 1400 K balances at 100 percent speed. The spool obeys a rotational energy equation.

Equations

  • Compressor work wc = cp T1 (π(γ-1)/γ - 1) / ηc, with π = 1 + 7 N².
  • Fuel-air ratio from (1+f) cph T4 - cp T3 = f ηb LHV.
  • Spool: J w dw/dt = m (ηm wt - wc).
  • Thrust F = m ((1+f) Ve - V0) with isentropic nozzle expansion.

Checks run in the page

  • Steady speed from root finding against the time-stepped spool-up.
  • The combustor energy balance.
  • Rotational energy change against the integral of net power.
  • Nozzle kinetic power against the enthalpy drop.

Honest simplifications

Fixed turbine expansion ratio, no compressor surge or stall, no variable geometry, no ram pressure recovery, constant specific heats in each section and no bleed or cooling air. It is a teaching model of spool dynamics, not an engine deck.

What to try
  • Press Slam to max: the spool accelerates and the net power falls to zero as it nears its new steady speed.
  • Press Idle after Slam to max: the spool decelerates on the same power-balance curve.
  • Compare the two power curves in the second plot: the steady state is where they cross.
Spool speed against time
Compressor and turbine power
Steady thrust against inlet temperature
Steady spool speed against inlet temperature