Presets
Playback
Apparatus
Model checks
The science
What is modelled
A four-seat high-wing aeroplane in steady, straight flight. The wing needs a lift coefficient that grows as speed falls, and the drag polar turns that lift into drag. The speed of the flattest glide and the speed of the slowest sink come from the same two numbers: the zero-lift drag and the lift-induced drag factor.
Equations
- Atmosphere
T = 288.15 − 0.0065 h + ΔT,p = 101325 (1 − 0.0065 h / 288.15)5.2559,ρ = p / (287.05 T). - Lift and drag
L = ½ ρ V² S CL,D = ½ ρ V² S CDwith the parabolic polarCD = CD0 + k CL²,k = 1/(π e AR). - Stall speed
Vs = √(2W / (ρ S CL,max)); best lift-to-drag1/(2√(CD0 k))atCL = √(CD0/k). - Steady glide angle
γ = atan(CD/CL); rate of climb(Pa − Pr) / W.
Checks run in the page
- A numerical search for the best lift-to-drag ratio against the formula.
- Stall speed by bisection against the closed form.
- The equations of motion integrated with RK4 for a glide, against atan(CD/CL).
- The climb rate from a full force balance against excess power.
Honest simplifications
A point-mass model with a parabolic polar and a linear lift curve up to a sharp stall; the propeller thrust curve and engine lapse are simple illustrative laws. There is no ground effect, wind, compressibility or pitch dynamics, and the numbers are not for flight planning.
What to try
- Press Engine out, best glide and read the glide angle, then Engine out, too slow and see the aircraft run out of lift.
- Raise the mass: the glide angle stays the same but the best-glide speed rises.
- Press Hot and heavy, 3000 m and watch the power available fall below the power needed at low speed.